The 3.6L Pentastar V6 has been one of FCA/Stellantis’ most common engines since 2011, powering millions of vehicles across the Jeep, Dodge, Chrysler, and Ram lineup. It delivers a balance of power and efficiency — but it also has some well-known issues.
The Pentastar is infamous for rocker arm/lifter tick, oil consumption, cylinder head failures (early models), and cooling system problems.
At DK Auto & Diesel Service in Magnolia, TX, we diagnose, repair, and upgrade Pentastar engines to keep them running strong in Jeeps, Rams, and Chrysler vehicles.
Common 3.6 Pentastar Problems & Symptoms
1. Rocker Arm & Lifter Tick
• Symptoms: ticking/tapping noise from engine, misfires, loss of power
• Causes: worn rocker arms & lifters, especially on passenger-side cylinder head
• Fixes: replace rocker arms/lifters with updated parts
2. Oil Consumption
• Symptoms: low oil between changes, blue smoke on startup or acceleration
• Causes: piston ring wear, valve seal wear, PCV issues
• Fixes: updated piston rings, PCV replacement, oil catch can installation
3. Cylinder Head Failures (Early Gen 1 Engines, 2011–2013)
• Symptoms: misfires on cylinder 2 or 4, check engine light, rough idle
• Causes: weak valve seats in early head designs
• Fixes: updated cylinder head replacement (covered under extended warranty on some models)
4. Cooling System Problems
• Symptoms: overheating, coolant loss, heater not working
• Causes: water pump & thermostat failures, radiator cracking
• Fixes: replace water pump, thermostat, and inspect radiator
5. Timing Chain & Guide Wear (High Mileage)
• Symptoms: rattling on startup, cam/crank correlation codes
• Causes: stretched chain, worn guides & tensioners
• Fixes: timing chain kit replacement with updated components
How DK Auto & Diesel Fixes the 3.6 Pentastar
- Rocker arm & lifter replacements (tick repair)
- Oil consumption repairs (rings, seals, PCV service)
- Cylinder head replacements (Gen 1 failure fix)
- Cooling system service (water pumps, thermostats, radiators)
- Timing chain replacements & upgrades
- Preventive maintenance packages for fleet and family vehicles
Schedule Your 3.6 Pentastar Diagnostic in Magnolia, TX
If your Jeep, Ram, Dodge, or Chrysler 3.6 Pentastar V6 is ticking, burning oil, or misfiring, bring it to DK Auto & Diesel Service for expert repair.
Serving Magnolia, Montgomery, Conroe, The Woodlands, Tomball, Willis, and Spring.
Book a Pentastar Diagnostic Today
FAQ About the 3.6 Pentastar
Is the Pentastar 3.6 a good engine?
- Yes — but Gen 1 (2011–2015) had common issues with head failures and rocker arm tick. Gen 2+ engines are more reliable.
How long will a Pentastar 3.6 last?
- With proper maintenance, 200k–250k miles is realistic. Many Jeep and Ram owners reach these numbers.
What’s the worst Pentastar problem?
- The rocker arm/lifter tick and oil consumption are the most common long-term issues.










